Chevrolet 2008 Impala Especificaciones descargar pdf (Pagina 293)

100

101

To disconnect the jumper cables from both vehicles,

do the following:

1. Disconnect the black negative (−) cable from the

vehicle that had the dead battery.

2. Disconnect the black negative (−) cable from the

vehicle with the good battery.

3. Disconnect the red positive (+) cable from the

vehicle with the good battery.

4. Disconnect the red positive (+) cable from the other

vehicle.

5. Return the fuse block cover to its original position.

Headlamp Aiming

Headlamp aim has been preset at the factory and

should need no further adjustment.

However, if your vehicle is damaged in a crash, the

headlamp aim may be affected. Aim adjustment to the

low-beam headlamps may be necessary if oncoming

drivers ﬂash their high-beam headlamps at you

(for vertical aim).

If the headlamps need to be re-aimed, it is

recommended that you take the vehicle to your

dealer/retailer for service.

Bulb Replacement

For the proper type of replacement bulbs, see

Replacement Bulbs on page 5-52.

For any bulb changing procedure not listed in this

section, contact your dealer/retailer.

Halogen Bulbs

{CAUTION:

Halogen bulbs have pressurized gas inside

and can burst if you drop or scratch the bulb.

You or others could be injured. Be sure to

read and follow the instructions on the bulb

package.

5-47

1 2 ... 288 289 290 291 292 293 294 295 296 297 298 ... 399 400

Comentarios a estos manuales

Sin comentarios

Chevrolet 2008 Impala Especificaciones Pagina 293

Comentarios a estos manuales

Relacionado con productos y manuales para Alarma de carro Chevrolet 2008 Impala